All-in-One Machine Controller

Up to 32 Axis

Smaller than the MP2300

The MP2300S is a small, all-in-one machine controller with MECHATROLINK and Ethernet (100Base-TX) ports, one basic module, and one optional slot.

Simplified Operation for Quicker Startup

Simply register the prepared motion programs in their order of execution. And, these programs will be executed in their registered order without the need to call up programs from the host PLC. By registering several motion programs, sophisticated motions are possible.

Synchronization of Distributed Systems with MECHATROLINK

Slave-CPU synchronization is a new function that has been added to MECHATROLINK. By connecting slave machine controllers to the master MP2000-series machine controller with MECHATROLINK, synchronous operation between slave controllers is possible. In this way, the total load can be divided, so the load of each slave controller is reduced and high-speed synchronous operation for multi-axis motions can be performed.

Supports All MP2300 Functions

Motion functions: Positioning, speed control, torque control, phase control, and electronic cam

Optional modules: Same as for other MP2000-series machine controllers

Servo system: JUNMA, Sigma-II/ III, Sigma-V , Linear Sigma, and Sigma Direct-drive series

With Ethernet Port (100 Mbps)

• High-speed communications with the touch panel (automatic message receiving)
• Communications with the host PLC without ladder programs (I/O message communications)
• High-speed communications with the MPE720 engineering tool

Applicable for Open Networks*¹

By mounting an optional module*², you can connect your system to a variety of open networks. This enables high-performance motion control with a PLC system.

*¹ Ethernet, CC-Link, DeviceNet, and PROFIBUS

*2 If using Ethernet to connect an MP2300S to the host PLC, no optional module is required.